Preparation; Connecting The Battery Charger - EUFAB 16615 Mode D'emploi

Masquer les pouces Voir aussi pour 16615:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
Keep packaging materials, especially plastic and plastic bags, away from children. Risk of suffocation!
Remove all plastic from the device before use.
Lay the mains cable in such a way that you are not hindered by it, and no one is able to accidentally pull it.
Disconnect the battery charger from the power supply after charging.
Keep the charger in a place that cannot be accessed by children or unauthorised persons.
Never operate the device in the vicinity of flammable materials or in an environment prone to explosion.
Always wear suitable working clothes, protective gloves and goggles. Battery acid is corrosive! Immedia-
tely and thoroughly wash off any splashed acid and consult a doctor if necessary. If battery acid gets into
the eyes, immediately rinse under running water for at least 10 minutes and consult a doctor.
Do not cover the charger, this may lead to overheating and result in damages. Never set the charger up for
operation on a surface that is insulating (e.g. polystyrene). There is a risk of heat build up!
If you wish to charge a vehicle battery in the installed state, first park the vehicle safely, put on the parking
brake and switch off the ignition. Cut the battery (positive terminal) off from the on-board network of
your vehicle. To do this, consult the manual for your vehicle, or ask your specialist workshop.
For vehicles with a start/stop system, please observe the specifications in the vehicle manual regarding
charging the battery and the connection points. In the event of further questions, contact the manufac-
turer of your vehicle.
When pulling the mains cable out of the socket, only hold the plug.
Never expose the charger to the vicinity of fire, heat and extensive temperatures over +40°C.
Do not leave the charger connected for more than 5 days.
Store these instructions carefully and, if necessary, pass them on to other users.
Operating instructions
Figure 1: Overview
1. Battery voltage display
2. 6 V charging programme
3. Winter charging programme
4. 12 V charging programme
5. Car charging programme
6. Motorbike charging programme
7. Battery charge status display

Preparation

Clean the battery pole of dust and corrosion residue. Only for open batteries: Top up with distilled water until the
minimum filling level is reached. Leave the cells of the battery open until the end of the charging process. With
maintenance-free batteries, follow the instructions of the battery manufacturer precisely.

Connecting the battery charger

Caution: Make sure that the charger is not connected to the power socket. Always first connect the red
plus cable (+) of the charger to the plus pole of the battery. Then connect the black minus cable (-) to the
minus pole of the battery. If you wish to charge the battery while it is installed, connect the black minus
cable (-) to the chassis, far away from the battery, carburettor and fuel lines. Always stick to this sequence.
A MODE button
B Display
C Charging cable
D Pole callipers, red (+)
E Pole callipers, black (-)
F Mains cable
Figure 2: Display
7

Publicité

Table des Matières
loading

Table des Matières