Performing A Functional Test - Dometic MWE9004 Instructions De Montage Et De Service

MagicWatch MWE9004, 9008
Configuring the rear control module
You can set the sensitivity of the sensors.
➤ Set parameter 17 to the required value.
0 = low ... 3 = high
Suppressing the display of fixed objects (such as trailer hitches)
(MWE9004/9008 rear control module)
A
NOTICE!
Make sure that there are no people or other objects behind the vehicle
during the set-up process.
➤ Set parameter 10 to 1, 2 or 3 until the fixed objects are no longer displayed.
The setting 0 deactivates this function.
Mirror function display (MWE9004 only)
You can switch the left display for the right display when using the LED display
9101500062.
➤ Set parameter 14 to 1.
Restoring the factory settings
➤ Press both buttons for longer than two seconds.
✓ The display shows F5.
10

Performing a functional test

To test the parking aid, drive towards something slowly such as a wall.
A
NOTICE!
Be very careful when you operate the device for the first time, and make
sure that you familiarize yourself with the various sequences of beeps
(fig. c).
EN
Performing a functional test
13