DeFelsko PosiTector DPM L Mode D'emploi page 3

PosiTector DPM L probes are designed to be used with the
PosiTector App or a PosiTector Advanced gage.
Power-up the PosiTector DPM L probe by unscrewing the top
cover (counter clockwise), then slide the power switch to the ON
( | ) position. The blue LED will flash once indicating the power is
ON. Replace the top cover.
The probe will begin broadcasting and is now visible to the
PosiTector App and PosiTector Advanced instruments within
10 m (30 feet). The probe will not begin logging until Logging
Mode (pg. 5) is enabled from the PosiTector App or a
PosiTector Advanced instrument.
NOTE:
Once Logging Mode is enabled, the PosiTector DPM
L probe will continue to log readings unattended while discon-
nected from the PosiTector App or PosiTector Advanced gage.
To power-down the probe, unscrew the top cover and slide the
power switch to the OFF ( O ) position.
Connecting to the Probe
using the PosiTector App
Install the PosiTector App from the
App Store (Apple iOS) or Google
Play (Android).
Open the PosiTector App. Available
probes will appear as "DPM L" with
the corresponding serial number and
most recent Dew Point temperature
reading, as shown at right. Select the
desired PosiTector DPM L probe to
connect.
NOTE:
The last measured Dew Point temperature reading is shown.
Quick Start
Quick Start
2