Section 8. Display Readings; Display Reasons And Descriptions - Jandy TruClear11K Manuel D'installation Et De Fonctionnement

Jandy TruClear Chlorine Generating System
® ™

Section 8. Display Readings

8.1

Display Reasons and Descriptions

Display Reading
EN
English
Standby
Standby ‡
Standby #
Chlorinating
Cleaning
Lo Temp/Lo Salt
No Flow
Check Cell
Check Cell
|
Installation & Operation Manual
Reason
Language on startup
Language
Standby
Connected to Jandy Automation
Connected to Jandy Variable Speed
Pump (with controller)
Chlorination
Polarity is reversing
Low water conductivity
No flow or low flow
Cell overload
Cell open circuit
ENGLISH
Description
This is the acronym which should appear
during the 3 seconds startup screen.
Language selected/available for the user.
Output is OFF while selection is made.
When the system is ready and waiting for
the next valid chlorination cycle without any
errors. Output is OFF.
When the system is connected to a
Jandy Automation System via RS485
communication cable and waiting for the next
valid chlorination cycle without any errors.
Output is OFF.
When the system is connected to a Jandy
Variable Speed Pump (with controller) via
RS485 communication cable and waiting for
the next valid chlorination cycle without any
errors. Output is OFF.
When the system is operating within a valid
chlorination cycle without any errors. Output
is ON.
When the system is operating within valid
chlorination cycle and the duty cycle timer
has expired. Output is OFF.
When the system detects low water
conductivity, this could be caused by cold
water, low salt levels, or a combination of the
two. Check the salt level. Output is ON.
When the system detects an absence of flow
while operating within a valid chlorination
cycle. Output is OFF.
When the system is running within a valid
chlorination window and detects a cell short
circuit or overload. Designed to warn the
user or service person. Output is OFF.
When the system is running within a valid
chlorination window and detects a cell open
circuit or disconnection. Designed to warn user or
servicer. Output is off but retries each 30 seconds.
Page 29