Jandy TruClear11K Manuel D'installation Et De Fonctionnement page 22

Page 22
ENGLISH
With all the variables mentioned above, it may take you a
couple weeks to fi nd the right production rate for your pool
To adjust the output level, follow these steps:
1. 1. Turn the power pack on by pressing the Turn the power pack on by pressing the
2. Press the buttons to reach the desired output
level. The minimum setting is 10%. The output can
be adjusted in increments of 10% up to 100%. This
controls the amount of run time for the cell.
Never use dry acid to adjust pH in arid geographic areas with excessive
evaporation and minimal dilution of pool water with fresh water. A build up of by
products can damage the electrolytic cell.
IMPORTANT Always test the chlorine levels of your pool before each use. During heavy
usage where bather load is increased, chlorine levels may deplete quickly and require
more adjustments. Monitor the chlorine closely, and take appropriate measures in
order to maintain the recommended 1 - 3 ppm free chlorine residual.
Figure 9. Total Hardness (United States)
Jandy TruClear Chlorine Generating System
® ™
button.
CAUTION
|
Installation & Operation Manual