Jandy TruClear11K Manuel D'installation Et De Fonctionnement page 5

Système de génération de chlore
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Jandy
TruClear
Chlorine Generating System
®
• The power pack must be installed at least 2 feet (0.6 m) vertically off the ground. Ensure the power pack is
protected from direct water exposure from sprinklers, water runoff from rooftops and drainage.
• In the US, the power pack must be installed at least 1.5 m (5 ft.) from the inside wall of your swimming pool or
spa; in Canada, the power pack must be installed at least 3 m (10 ft.) from the inside wall of your
swimming pool or spa.
• In Canada, the Jandy chlorine generating electrolytic cell must be installed outdoors.
• The cell must be installed horizontally with the cord facing upwards to avoid buildup of flammable gases which
can result in FIRE OR EXPLOSION.
• The cell must be installed as the last piece of equipment in the circulation plumbing system just before the pool.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
To reduce the risk of injury, do not remove the suction fittings of your spa or hot tub. Never operate a spa or hot
tub if the suction fittings are broken or missing. Never replace a suction fitting with one rated less than the flow rate
marked on the equipment assembly.
PREVENT CHILD DROWNING: Do not let anyone, especially small children, sit, step, lean or climb on any
equipment installed as part of your pool's operational system. Locate the components of your operational system
at least 1 m (3 ft.) from the pool so children cannot use the equipment while in the pool and be injured or drown.
Prolonged immersion in hot water may induce hyperthermia. Hyperthermia occurs when the internal temperature
of the body reaches a level several degrees above the normal body temperature of 37 °C (98.6 °F). The symptoms
of hyperthermia include dizziness, fainting, drowsiness, lethargy, and an increase in the internal temperature of the
body. The effects of hyperthermia include:
• Unawareness of impending danger
• Failure to perceive heat
• Failure to recognize the need to exit spa
• Physical inability to exit spa
• Fetal damage in pregnant women
• Unconsciousness resulting in a danger of drowning
To Reduce the Risk of Injury -
The water in a spa should never exceed 40°C (104°F). Water temperatures between 38°C (100°F) and 40°C
(104°F) are considered safe for a healthy adult. Lower water temperatures are recommended for young
children and when spa use exceeds 10 minutes.
Since excessive water temperatures have a high potential for causing fetal damage during the early months of
pregnancy, pregnant or possibly pregnant women should limit spa water temperatures to 38°C (100°F).
Before entering a spa or hot tub, the user should measure the water temperature with an accurate
thermometer since the tolerance of water temperature-regulating devices varies.
The use of alcohol, drugs, or medication before or during spa or hot tub use may lead to unconsciousness with
the possibility of drowning.
Obese persons and persons with a history of heart disease, low or high blood pressure, circulatory system
problems, or diabetes should consult a physician before using a spa.
Persons using medication should consult a physician before using a spa or hot tub since some medication
may induce drowsiness while other medication may affect heart rate, blood pressure, and circulation.
|
Installation & Operation Manual
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
Page 5
ENGLISH

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Truclear11ku

Table des Matières