Jandy TruClear11K Manuel D'installation Et De Fonctionnement page 28

Page 28
ENGLISH
Problem
Salt level too high.
Strong Chlorine odor.
Cloudy water, slimy
walls of pool.
Eye and/or skin
irritation.
Scale formation on
pool equipment.
Jandy TruClear
®
Possible Cause
Too much salt has been added to pool.
Metal debris caught between plates or
cell plates that may be touching.
Presence of excess chloramines
(combined chlorine).
Chlorine is an oxidizer, which means that
organic waste is being removed from the
water into the air. Strong odors are a part
of this process. If these odors persist
longer than 12 hours, take a water
sample to your local pool dealer.
Combined algae and bacteria growth.
Improper water balance.
High chloramine levels
High calcium hardness.
Incorrect pH causing minerals to come
out of solution.
NOTE To clean the deposit (scale) on the cell, see Section 6.3.
|
Chlorine Generating System
™
Corrective Action
Verify salt levels by testing. Using the most
reliable method available i.e. taking sample
to pool dealer before taking any dilution
action. Backwash or partially drain pool
and dilute with fresh water until salinity
returns to 3,000 ppm - 3,500 ppm.
Remove any debris caught between plates
by using a garden hose under moderate
pressure. If plates are loose and touching,
replace the cell.
Manually shock the pool
(see Section 4.3).
Brush down the affected walls and then
manually shock the pool
(see Section 4.3).
Balance the water to recommended levels
in Section 4.4.
Raise production rate to 100% and run
pump for 24 hours.
DO NOT SWIM DURING THIS TIME
Dilute pool with fresh water. Consult your
pool professional regarding use of a
sequestering agent.
Adjust total alkalinity to 80 - 120 ppm (U.S.)
or 100 - 120 (Canada). Then adjust pH to
within the range 7.4 - 7.6 (see Section 4.4).
Installation & Operation Manual