LAVAZZA LB2210 Manuel D'installation Et D'utilisation page 13

The "Aqua Prima" fi lter must be replaced when the machine sig-
nals to do so.
Before descaling, the "Aqua Prima" fi lter must be removed from
the water tank.
In order to ensure a correct use of the "Aqua Prima" fi lter, please observe the
following recommendations:
1. Store the "Aqua prima" fi lter in a cool place away from the sun, at a tem-
perature between +5°C and +40°C;
2. Use in areas with temperature not higher than 60°C.
3. It is advisable to wash the "Aqua prima" fi lter if the machine has been inac-
tive for 3 days or more;
4. Replace fi lter if the machine has been inactive for 20 days or more;
5. To preserve a fi lter that has already been opened, place in a plastic airtight
bag and store in the refrigerator; do not store in freezer, as this will alter the
properties of the fi lter;
6. Before using the fi lter, place in the water tank for 30 minutes;
7. Once removed from its package, do not store fi lter in the open air;
8. The fi lter must be replaced within 90 days after it has been removed from its
package, or after it has fi ltered 60 litres of drinking water.
To install the "Aqua Prima" fi lter, proceed as follows:
1 using the key supplied with the machine, open the lid of the water tank and
lift it off.
2 Lift out the tank using the handle provided.
3 take the "Aqua Prima" fi lter from its package and insert it into the tank; posi-
tion the reference mark so that it corresponds to the slot;
4 insert fi lter and push fully as you make light oscillating movements;
5 fi ll the water tank with fresh drinking water and correctly place the tank back
in the machine.
Note: before using the fi lter, leave it immersed in water for about
30 minutes, for its activation.
Warning! The tank may be fi lled only with fresh drinking water. Hot
or carbonated water or other liquids will damage the machine.
When fi lling the tank, never exceed the maximum level.
After fi lling the water tank, set it back in place, taking care to position it
correctly; in this manner the valve situated at the bottom will open and allow
the machine to work properly.
Replace the lid on the water tank.
Lock the lid in place using the key provided.
6 go to the programming menu section 10.1 and enable the fi lter replacement
control (2.6. Filter warning);
Go to the service menu as directed in section 10.2 and display the fi lter activa-
tion menu.
5.
Enable filter
Using the appropriate controls, select "Yes" to perform fi lter activation.
5.
Enable filter
Yes
• 13 •