Changing The Battery; Setting The Unit; Weighing; Tare - SilverCrest SKWD B1 Instructions D'utilisation Et Consignes De Sécurité

Start-up / Changing the battery / Operation / Troubleshooting
Replace the battery cover. Be sure the two
extensions on the battery cover engage in the
opening for the battery cover. Press the battery
cover onto the battery compartment until you
hear and feel it lock into place.

Changing the battery

Open the battery compartment at the back of
the kitchen scales
Remove the drained battery.
Insert the new battery (1 x CR2032). Check the
polarity of the battery during insertion. The „+"
sign must point upward and the battery remain
inside the battery compartment.
Close the battery compartment as described
above.
Operation
Setting the unit (Fig. B)
Place the kitchen scales
and flat surface.
Press the ON / OFF button / TARE button
switch on the kitchen scales
Select the weight unit by pressing the UNIT
button . You may select between „g", „oz",
4
„lb:oz", „ml", „fl.oz".
Weighing (Fig. C)
Place the kitchen scales
and flat surface.
Press the ON / OFF button / TARE button
switch on the kitchen scales
will read „0".
10 GB/IE
as described above.
1
on a solid, level,
1
3
.
1
on a solid, level,
1
3
. The LC display
1
Place the item you wish to weigh onto the
scales. The LC display
of the items.
Tare (Fig. C)
First follow the three steps in section „Weighing".
Briefly press the ON / OFF button / TARE
button . The LC display
3
and „TARE" will appear.
Add other items you wish to weigh to the
scales. The LC display
of the item added.
When removing the added items from the
scales, the LC display
When removing all items being weighed, the
scales will display a negative value.
Briefly press the ON / OFF button / TARE but-
ton . The LC display will read „0".
3
Switching off the scales (Fig. C)
To save power, the kitchen scales
cally switch off after approx. 180 seconds of inac-
to tivity.
To manually switch off the kitchen scales
press and hold the ON / OFF button / TARE
button for 2–3 seconds.
3
Troubleshooting (Fig. D)
= Error
= Cause
to = Solution
will show the weight
2
will read „0"
2
will show the weight
2
will read „0".
2
will automati-
1
,
1