Copyright; Prior To Use; Inserting / Removing The Battery - SilverCrest SPWD 180 B1 Mode D'emploi

SilverCrest SPWD 180 B1
purpose! Contact with skin must be avoided. In the event of
skin or eye contact with chemicals, they must be immediately
rinsed with generous amounts of water and a doctor must be
consulted.

Copyright

All information contained in these instructions is subject to copyright and is provided for information
purposes only. It is only permitted to copy or duplicate data and information with the express and
written consent of the author. This also includes commercial use of the content and data. The text
and illustrations are based on the state of the art at the time of printing. Subject to change.

Prior to use

Inserting / removing the battery

To insert the lithium battery CR2032, remove the
cover from the battery compartment (7) on the
bottom of the diagnostic scales by pressing the
ribbed surface with your finger and then sliding
the cover off sideways. Then insert the supplied
lithium battery CR2032. Pay attention to the
polarity when inserting the battery. This is
indicated in the battery compartment (7), and the
+ symbol on the lithium battery CR2032 must be
visible, as shown in the illustration.
To remove the battery, push it down a bit (see the
direction of the arrow in the illustration). You can
then remove the battery from the holder.
Then replace the
compartment (7). The diagnostic scales are now
ready to use.
50 - English
cover on the battery