Belkin F5D7632-4 Manuel De L'utilisateur page 56

Manually Configuring Network Adapters
2. Select "Network" (1) from the "System Preferences" menu.
3. Select "Built-in Ethernet" (2) next to "Show" in the "Network" menu.
(1)
4. Select the "TCP/IP" tab (3). Next to "Configure" (4), you should see "Manually"
or "Using DHCP". If you do not, check the PPPoE tab (5) to make sure that
"Connect using PPPoE" is NOT selected. If it is, you will need to configure your
Router for a PPPoE connection type using your user name and password.
(5)
(2)
(3)
(4)
5. If "Manually" is selected, your Router will need to
be set up for a static IP connection type. Write the
address information in the table below. You will need
to enter this information into the Router.
6. If not already selected, select "Using DHCP" next to
"Configure" (4), then click "Apply Now".
Your network adapter(s) are now configured for use with the Router.
54 54