Belkin F5D7632-4 Manuel De L'utilisateur page 23

Manually Configuring your Router
Setting your Connection Type to Modem Only (Disable Internet Sharing)
In this mode, the Router simply acts as a bridge passing packets across the DSL
port. It requires additional software to be installed on your computers in order to
access the Internet.
(1)
(2)
1. VPI/VCI — Enter your VPI and VCI parameter here. (Assigned by your ISP).
2. Encapsulation — Select LLC or VC MUX. (Assigned by your ISP).
DNS (Domain Name Server) Settings
A "Domain Name Server" is a server located on the Internet that translates
Universal Resource Links (URLs) like "www.belkin.com" to IP addresses. Many
ISPs do not require you to enter this information into the Router. The "Automatic
from ISP" box (1) [Designer: call this out in screenshot below] should be checked
if your ISP did not give you a specific DNS address. If you are using a static
IP connection type, then you may need to enter a specific DNS address and
secondary DNS address for your connection to work properly. If your connection
type is dynamic or PPPoE, it is likely that you do not have to enter a DNS
address.
Leave the "Automatic from ISP" box checked. To enter the DNS address
settings, uncheck the "Automatic from ISP" box and enter your DNS entries
in the spaces provided. Click "Apply Changes" (2) [Designer: call this out in
screenshot below] to save the settings.
(1)
21 21
1
2
3
4
5
6
7
8
9
10
11
(2)