Maintenance; Maintenance Table - Airpress HL 425-24 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6.0 MAINTENANCE

Before carrying out any maintenance jobs it is obligatory to stop the
machine, disconnect it from the power mains and make sure that the
tank is pressure free by opening the condensation draintap (10).
1. After the first 50 operating hours and then every 250 operation hours the oil
should be refreshed. Turn off the oil drain plug (11) and also remove the filler
cap (13). Collect the oil. If the oil does not come out any longer, switch on the
drainplug again and refill the oil (through fillercap) until the oil has reached the
correct level (0,5 liter)
The right oil level is on the red circle on the oil leveler (12).
Always respect the regulations in force for disposing of old oil!
2. Regularly drain condensation water. The draintap is situated at the bottom of
the tank (10). Draining with pressure in the tank is the easiest way. Some
compressors have an aftercooler with its own drainplug. Also from this device
the condensationwater should be drained regularly.
Condensate must be disposed of in conformity with the local regulations
in force (not in the sewer!).
As an alternative you can place an oil/water separator.
3. The oil level should also be checked regularly. For the right oil level see point
1. If necessary refill with compressor oil, order No 12491 (0,6 l l) or order No
12492 (1 l). Checking daily can prevent a lot of troubles!
Use oil of the same type as that already in the machine; do not mix
different types of oil!
4. The air filter element (1) should be cleaned or changed regularly. This change
depends on the amount of fouling and should be done more often in dusty
situations and less often in a clean situation. For cleaning the filterelement,
take out the filtercontainer with the filter. Then clean the filter by blowing off
the dust.
Note: Regular maintenance of your compressor will increase durability and
reliability.

MAINTENANCE TABLE

works
draining
condensation water
check
oil level
clean
air filter
refresh oil (first time
after 50 hours)
daily
weekly
25
every
every
250 hours 1000 hours

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hl 425-50Hl 425-100 v

Table des Matières