Table des Matières
Publicité
Should the machine be altered in any way, this statement
of conformity is invalidated.
Machine category:
Scroll saw
Type of Machine:
deco 405
Relevant EC directives:
EC machine directive 98/37/EG (< 28.12.2009),
EC machine directive 2006/42/EG (> 29.12.2009),
EC Low voltage directive 2006/95/EWG,
EC-EMV directive 2004/108/EWG.
Harmonized European standards applied, especially
EN 55014-1, EN 55014-2, EN 60555-2, EN 60555-3
Notified body
TÜV Rheinland, Product Safety
Am Grauen Stein
D-51105 Köln
Place, date:
Ichenhausen, 03.07.2009
Signed:
Warning: In the interest of plant safety, always turn the saw off and unplug it before you begin maintenance work.
Fault
Saw blades break
Motor does not function
Vibration
NOTE: The saw vibrates slightly
when the motor is running in
normal operation.
Saw blade swings out
Holders not aligned straight
14 english
i.V. Wolfgang Windrich (product manager)
Troubleshooting
Possible causes
Tension incorrectly set
Load to great
Incorrect saw blade variety
Workpiece not fed straight
Mains Gable faulty
Motor faulty
Saw incorrectely installed
Unsuitable underlay
The work bench is not screwed
down or is on the motor
The motor is not secured
Holders not aligned
Action
Set the correct tension
Feed the workpiece more slowly
Use the correct saw blades
Avoid exerting pressure from the
side
Change faulty parts
Call customer service. Do not
attempt to repair the motor yourself
as this should be carried out by
trained personnel.
Refer to the instructions given
earlier in this manual for
information on installing the saw
The heavier the work bench is,the
less the vibration. A bench made
from ply wood always vibrates more
than one made from solid wood.
Select the work bench best suited
to your working conditions
Tighten the locking lever
Securely screw the motor in place
Losen the screws with which the
holders are fastenedto the arm.
Align the holders so that they are
perpendicular to each other and
retighten the screws.
Publicité
Table des Matières
