The Cable; The Belt (Optional) - Hocoma Valedo Manuel De L'utilisateur

The sensors are equipped with an LED that blinks and flashes to communicate
what it's doing or if it needs charging. Below is a table with the different LED modes
and their explanations.
LED mode
On
Inverted pulse:
Long on - short
off
Off
Off
Pulse: Short on –
Long off
Slow flash (1
second on, 1
second off)
Fast flash (~0.5
second on,~0.5
second off)
Triple flash (3x
per second)
* Warning messages and low battery alerts will also appear on the computing device.
Do not soak or submerge the sensors in any liquid. Use a damp cloth to
wipe surfaces.

The Cable

The cable that ships with Valedo is a standard USB to dual micro-USB cable. Use
this cable for both charging and firmware updates of the sensors.
Both micro-USB connectors can be used to charge, but only one can be used for
firmware updates. Simply put, you can charge both sensors simultaneously, but
you can only update one sensor at a time. For information on updating the sensors,
see the Maintenance section below.
Figure 2: USB head on the left, two micro-USB heads on the right. Micro-USB head in the middle

The Belt (optional)

If you wish to train without using the double-sided medical tape, consider our
specially designed belt. The sensor simply snaps into the belt buckle. Easily adjust
the size by pulling the loose cord.
The belt is an optional accessory available for purchase from Hocoma. Go to
1
www.valedotherapy.com
Chapter 1: Overview and Safety
V_UM1.1_en_1407
Sensor
status
Charging—
fully charged
Charging—
not fully
charged
Standby
Deep Sleep
Awaiting
connection
Connected
Connected—
alert
Battery low
can be used for both charging and firmware updates.
1
for details.
Mode explanation
The sensors are plugged in and are
fully charged.
The sensors are plugged in but are
not yet fully charged.
The sensors are not actively
searching for a Bluetooth signal.
Shake to turn sensors back on.
The sensors have turned themselves
off. This happens after 48 hours in
standby mode. Press button to turn
sensors back on.
The sensor is on and waiting for the
Bluetooth connection with the
computing device.
The sensor is on and correctly
connected via Bluetooth with the
computing device.
The sensor is on and connected with
the computing device, but there is a
warning message.*
The sensor is running low on battery
and needs to be charged.*
6