Fcc And Ic Statements; Risk Management - Hocoma Valedo Manuel De L'utilisateur

FCC and IC Statements

Statement according to Part 15.105
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
Statement according to Part 15.19 and RSS-210
Part 15 of the FCC Rules and with Industry Canada license-exempt RSS
standard(s).
Operation is subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that
may cause undesired operation.
Statement according to Part 15.21
Changes or modifications made to this equipment not expressly approved by
Hocoma may void the FCC authorization to operate this equipment.
RF Exposure Information according to 2.1091 / 2.1093 / OET bulletin 65
Radiofrequency radiation exposure Information
The radiated output power of the device is far below the FCC radio frequency
exposure limits.

Risk Management

Connection of Valedo to a computer network that includes other equipment could
result in previously unidentified RISKS; identify, analyze, and control such RISKS
(refer to IEC 60601-1:2005)
Subsequent changes to a computer network could introduce new RISKS and
require new analysis.
Changes to the computer network include:
 Changes in computer or data network configuration
 Connection of additional items to computer network
 Disconnecting items from computer network
 Update of equipment connected to computer network
 Upgrade of equipment connected to computer network
The term computer network used here corresponds to the term network/data
coupling in IEC 60601-1:2005.
Chapter 4: Technical Specifications
V_UM1.1_en_1407
20