Problems During The Training Session - Hocoma Valedo Manuel De L'utilisateur

Masquer les pouces Voir aussi pour Valedo:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problems During the Training Session

Issue
The sensor(s) fall(s)
off.
The avatar in the range
of motion (ROM)
settings screens does
not show the correct
movement.
During training
exercises, the avatar
moves about rapidly.
The avatar does not
move when doing the
exercises.
The indicator LEDs
show they are
connected (see
Chapter 1 for LED
modes) but avatar
does not move.
The movement
required in the game is
larger than what you
can do.
After training, you see
reddening or irritation
under where the
sensors were attached
to the skin.
Chapter 5: Troubleshooting
V_UM1.1_en_1407
Action
 Clean the back of the sensor with a soft damp
cloth before placing a new strip of double-sided
tape.
 Wipe the areas of the skin where you will attach
the sensor(s) with a soft damp cloth before
reattaching.
 Dry your skin and sensor before attaching the
tape and mounting the sensor to your body
 Reattach the sensor and press firmly for 5
seconds to make sure sensor sticks to your
skin.
 If all of the above suggestions do not work, then
you may have to consider acquiring the training
belt from Hocoma.
 Make sure that the sensors are still
communicating with the computing device.
 Redo the ROM settings making sure to stand
very still while the sensors calibrate and only
bow to confirm and proceed when indicated to
do so.
 Stop the exercise and redo the range of motion
(ROM) settings. Having a very small ROM will
make for an exaggeratedly sensitive avatar
movement during gameplay.
 Turn sensors off and on again.
 Restart computing device.
 Restart Valedo App.
 Make sure that the sensors are still on and
communicating with the computing device.
 Turn sensors off and on again.
 Restart computing device.
 Restart Valedo App.
 Make sure that the sensors are still
communicating with the computing device.
 Turn sensors off and on again.
 Restart computing device.
 Restart Valedo App.
 Reset Exercise ROM values.
 Setting up correct and accurate ranges of
motion during the Exercise ROM is critical;
therefore, do not compensate or overexert
when setting up these parameters. This will
ensure that the in-game movements required
do not exceed what you are physically capable
of doing. See Chapter 3 for info on setting the
ROM.
 This might indicate an allergic reaction to the
double-sided tape. Stop training immediately
and consult with your dermatologist before
continuing Valedo training.
22

Publicité

Table des Matières
loading

Table des Matières