Installing The Filters - Winix T1 Guide De L'utilisateur

INSTALLING THE FILTERS

This product comes with all of the required filters. The protective plastic wrap must be
removed from the filters before use.
 Operating the unit without removing the plastic wrap may result in product failure.
 Unplug and make sure the unit is turned off before installing filters.
 On the edge of each filter will show which way should face up.
Remove the Filter Cover
①
x Squeeze the the two tabs towards the
middle and pulling it toward yourself.
Remove the bottom filters from the
②
unit, they are protected inside
plastic wrap.
Remove filters from protective
③
plastic wrap.
x Operating the unit without removing
filters from plastic wrap may cause
abnormal noise, deformation, or fire as a
result of overheating.
Install the bottom filters.
④
x Insert the filters into the
appropriate slots until the
back of the filter touches
the rear of the unit.
Replace the Filter Cover.
⑤
x Squeeze the the two tabs towards the
middle and attach it back to the unit.
English
3
High
Capacity AOC
Carbon Filter
2 Anti-microbial
PM 2.5 Filter
1
Fine Mesh Pre-Filter
| Set up
Installation
TM
9
T1