Installing The Filters - Winix NK100 Guide De L'utilisateur

INSTALLING FILTERS
This product comes with all required filters. The protective plastic wrap
must be removed from the filter before use.
※ Operating the unit without removing the plastic wrap may result in
product failure.
※ Unplug and make sure the unit is turned off before installing filter.
① Remove the back panel by grasping
handle and pulling back, towards
yourself.
② Once the back panel is removed, grasp
the handle near the bottom of the unit,
and pull towards yourself to lower and
release the filter.
③ Remove the
HEPA filter from the unit. Remove the
plastic wrap from the filter.
• Operating the unit without removing
filters from plastic wrap may cause
abnormal noise, deformation, or fire as a
result of overheating.
Note
• Refer to pages 17 - 19 for details on how to replace filters.
English
Latch
o
360 All-in-One True
8
NK100