Installing The Filters - Winix ZERO Pro Manuel D'utilisation

INSTALLING THE FILTERS

This product comes with all of the required filters. The protective plastic wrap must be
removed from the filters before use.
※ Operating the unit without removing the plastic wrap may result in product failure.
※ Unplug and make sure the unit is turned off before installing filters.
※ The unit will automatically power off when front panel is opened.
Remove the front panel by grasping its
①
upper edge and gently pulling towards
yourself.
ˍ To remove the front panel, the latch at
the lower edge of the panel must be
released from its position.
Remove the filters from the unit, they are
②
protected inside a plastic wrap.
Remove filters from protective plastic wrap.
③
ˍ Operating the unit without removing
filters from plastic may cause abnormal
noise, deformation, or fire as a result of
overheating.
Note
English
ˍ Refer to pages 15 - 18 for detailed information on filter care
and how to replace them.
Latch
ZERO Pro
6