Installing The Cart To The Main Grill; Securing The Door Stopper, Door Magnet; Attaching The Cabinet Doors - Louisiana Grills LG Série Guide D'utilisation

3. INSTALLING THE CART TO THE MAIN GRILL

Parts Required:
1 x Main Grill (#6)
2 x Lift Handles (#11)
Screw (#A)
16 x
Installation:
• Prepare the main grill to be mounted to the cart. Position the cart next
to the main grill, with both facing the same direction.
IMPORTANT: Once positioned, lock the caster wheels on the cart.
• Install the lift handles by inserting them into the rear/exterior of
the back cart panel. Tilt the lift handles upward so they brace into a
locking position on the main grill. Note illustration 3A.
• Using a second person, each place one hand in the grease tray opening
(front facing) and one hand on a lift handle (rear facing). Carefully, lift
the main grill, and slowly lower the brace frame of the main grill onto
the four support legs of the cart. Once placed, secure each leg to the
brace frame using four screws. Repeat same installation for the other
three support legs. Note illustration 3B.
NOTE: When fitted properly, the main grill should be sitting level
and flush with the cart panels.

4. SECURING THE DOOR STOPPER, DOOR MAGNET

Parts Required:
Door Magnet (#13)
1 x
Door Stopper (#14)
1 x
4 x Screw (#B)
Installation:
• Secure the door stopper to the bottom shelf using two screws, with
the raised stop facing the back of the cart.
• Mount the door magnet using two screws to the frame lip, below the grease
tray opening. Ensure the raised magnet is facing the front of the cart.

5. ATTACHING THE CABINET DOORS

Parts Required:
2 x Cabinet Door (#23)
4 x Cabinet Door Protector (#22)
Cabinet Door Handle (#21)
2 x
Installation:
• From the rear of the cabinet door, insert the two cabinet door plugs
into the large holes near the edge. Remove the pre-installed screws
from both cabinet door handles. Insert one of the screws into the
cabinet door protector, so it protrudes to the front of the cabinet
door. Use a screwdriver to tighten the screw into the cabinet door
handle (from the rear). Repeat same steps for the other side of the
cabinet door handle. Note illustration 5A. Repeat full installation for
the second cabinet door.
8
3A
3B
4
5A