Preparing The Cable; Video Cable; Cable Connection - Samsung SCC-641(P) Manuel D'instruction

Preparing the Cables
To install and use the SCC-641(P), the following cables should be prepared.
Power Adapter Cable
The cable connected to the Power input terminal of the SCC-641(P) is shown below with
a rated voltage of 24VAC and ampacity of 15A.

Video Cable

The SCC-641(P)'s cable is a BNC Cable for connecting the video-output terminal to
the video-input terminal of the monitor.
2-5

Cable Connection

1. First, connect one end of the BNC video cable connector to the Video Output
Terminal (VIDEO OUT)
2. Then, connect the other end of the connector to the Video Input Terminal of
the monitor.
3. Now connect the Power Adapter Cable. Use a driver to screw one part of the two
lines of Power Adapter to Power Input Terminal of the SCC-641(P).
4. Adjust the switch below the Power Adapter to the proper voltage. Then, connect
the Power Adapter's plug to the Power Connector.
5. Connect the Remote Control Terminal of the SCC-641(P) and the external
Controller.
E
2-6