Dust Filter Cleaning And Integrity Check - Clarke RSW 37 Manuel D'utilisation

ENGLISH

DUST FILTER CLEANING AND INTEGRITY CHECK

NOTE
Besides the standard paper fi lter, polyester fi lters
are also available. The following procedure is
applicable to each type of fi lter.
1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition switch (72) to "0".
3. Remove the hopper hook (21).
4. Remove the hopper (20) with the handle (22).
5. Turn the handle (A, Fig. 9) downwards (90°
approximately) and let the fi lter frame (B) turn outwards.
6. Remove the dust fi lter (C).
7. In an outdoor area, clean the fi lter by shaking it on a level
and clean surface, tapping the side (A, Fig. 10) opposite
to the wire gauze (B). Complete the cleaning procedure
by using compressed air (C) at maximum 6 Bar, blowing
only from the side protected by the wire gauze (2), at a
minimum distance of 11.8 in (30 cm).
According to the fi lter type, observe the following
cautions:
• Paper fi lter (standard): Do not use water or
detergents to clean it; the fi lter can be damaged.
• Polyester fi lter (optional): To clean it, see the above-
mentioned instructions. If necessary, for a better
cleaning, it is allowed to wash the fi lter with water
and non-lathering detergents. This provides better
quality cleaning but reduces the life of the fi lter,
which will have to be replaced more frequently. Using
inadequate detergents can damage the fi lter.
8. Check the fi lter body for tears.
9. If necessary, clean the fi lter compartment rubber gasket
(D, Fig. 9) along its perimeter and check it for integrity. If
necessary, replace it.
10. Assemble the components in the reverse order of
disassembly.
11. Assemble the components in the reverse order of
disassembly, and pay particular attention to the following:
• Install the fi lter (A, Fig. 10) with the wire gauze (B)
facing the vacuum fan (56).
18
C
B
D
A
Figure 9
11,8 in
6 Bar
Figure 10
Operator's Manual - RSW 37
S310200C
A
C B
S310036C