Functional Description - Bosch GSZ 160 Professional Notice Originale

OBJ_BUCH-465-002.book Page 13 Thursday, November 26, 2009 8:34 AM

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
The machine is intended for cutting sheet metal
without deforming the material and is suitable
for straight cuts, cut-outs and narrow curves.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Blade
2 Cutter bars
3 Screws for cutter bar
4 Blade bolts
5 On/Off switch
Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Bosch Power Tools
Technical Data
Slot Shear
Article number
Rated power input
Output power
Stroke rate at no load n
0
Stroke speed under
load
Cutting speed m/min
Max. steel sheet cut-
1) 2)
ting capacity
Smallest curve radius
with blade for:
– Straight cut
– Curved cut
Weight according to
EPTA-Procedure
01/2003
Protection class
2
1) to 400 N/mm with reference to steel sheet
2) with blade for straight cut
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Noise/Vibration Information
Measured sound values determined according
to EN 60745.
Typically the A-weighted noise levels of the prod-
uct are: Sound pressure level 85 dB(A); Sound
power level 96 dB(A). Uncertainty K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Vibration emission value a
h
2
ty K < 1.5 m/s .
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
1 609 929 M55 | (26.11.09)
English | 13
GSZ 160
Professional
0 601 521 0..
W 500
W 270
-1
min 5600
-1
min 3600
6–10
mm 1.6
mm 90
mm 30
kg 1.6
/ II
2
= 7 m/s , Uncertain-