Changing The "Pvc" Pads On The Vices; Vice Cylinder Replacement; Cleaning The Vice Cylinder Stop Valve - FOM INDUSTRIE SIKA PLUS Manuel D'emploi Et D'entretien

GB
SIKA PLUS
10.5 CHANGING THE "PVC" PADS ON THE VICES (Fig. 10-07)
- Undo the fixing screws "A" and pull out the pads to be changed "B".

10.6 VICE CYLINDER REPLACEMENT

1) Disconnect the hose from the filter and lock the ON/
OFF switch in the "OFF" position using a padlock.
2) Unscrew vice roll "B" - Fig. 10-07.
3) Loosen handle "C" - Fig. 10-08 and pull out the
cylinder.
4) Disconnect the air ducts.
5) Insert the roll on the new cylinder or replace it if
necessary.
6) Place the new cylinder inside its support and lock with
handle "C" - Fig. 10-08.
7) Connect the hoses to the union.
8) Re-connect the hose to the machine and take off the
padlock.
9) Test.
10.7 CLEANING THE VICE CYLINDER STOP VALVE (Fig. 10-09)
Remove metal ring "A" with a screwdriver; take out the stop valve cap "B"; take out the stopper "C" and clean it being
careful of the springs fitted to the stopper, then reassemble all the components.
N.B. Do not unscrew the valve body "D" from the cylinder body "E", because there is a preloaded spring inside
which would expel the piston.
C
56
A
B
10-07
10-08
10-09