Cutting Angles; Head Rotation - FOM INDUSTRIE SIKA PLUS Manuel D'emploi Et D'entretien

GB
SIKA PLUS
8.3

CUTTING ANGLES

8.3.1 HEAD ROTATION

The head of the SIKA PLUS can be rotated as follows:
- From 90° to 45° RH
- From 90° to 45° LH
By first undoing knob "1" - Fig. 08-03 and then pulling button "2" - Fig. 08-03 the head is free to rotate.
Use the handle "3" - Fig. 08-04 to rotate the head to the required position.
Mechanical end of travel stops determines the positions:
- 90°
- 45° RH
- 45° LH
The intermediate cutting positions are obtained, after pulling out button "2" - Fig. 08-03, by rotating the blade using
the handle "3" - Fig. 08-04.
The vernier scale is etched into the work table
Reading off the angle required, secure the head by tightening knob "1" - Fig. 08-03 and releasing button "2" -
Fig. 08-03.
2
3
1
46
08-03
08-04