Operating - FOM INDUSTRIE SIKA PLUS Manuel D'emploi Et D'entretien

9

OPERATING

9.1 OPERATING - SIKA PLUS MANUAL
The machine has a manual down-feed, while the vices and the atomised cutting lubrication are pneumatic.
Check:
- That the power supply voltage is the same as that of the machine.
- The blade rotation direction.
After adjusting the position of the vices in relation to the profile to be cut, position the profile on the work table.
By setting the pneumatic button "A" - Fig. 09-01 fully forwards the vices clamp the profile.
CAUTION:
Check carefully that the vices are not within the working range of the blade.
Turn the main switch to position I.
Lowering lever "B" - Fig. 09-01 activates the cutting atomisation, then the profile clamped on the work table is cut.
When the head is sent back upwards the atomisation stops,
By positioning the pneumatic button "A" - Fig. 09-01 fully backwards the vices can be opened and the work table freed
for the next cut.
CAUTION:
Never carry out cutting operations without first tightening the two vices.
B
A
51
GB
SIKA PLUS
09-01