Electrical And Pneumatic Connections; Electrical And Air Connection Components; Before Starting; Connection To The Electrical Power Supply - FOM INDUSTRIE SIKA PLUS Manuel D'emploi Et D'entretien

GB
SIKA PLUS
7

ELECTRICAL AND PNEUMATIC CONNECTIONS

7.1 ELECTRICAL AND AIR CONNECTION COMPONENTS (Fig. 07-01)
1 - On/Off switch
2 - Air intake filter
SIKA PLUS AUTOMATIC
1

Before starting

Before starting the machine, it must first be checked that the mains power supply is efficient, safe and reliable,
protected by an automatic supply line switch and properly earthed. This applies also to the compressed air supply
which must be of sufficient section for the required capacity and a valve fitted so that the supply can be cut off to the
machine. If the air distribution line is of considerable length, then appropriate release barrels must be provided at
suitable points to drain off the condensation .
Before carrying out any operations of this sort, make sure that the power supply available is the same as that required
by the machine. Check that the main switch (400 V - three-phase) is set to 0 (zero).

Connection to the electrical power supply

A - 400 V THREE-PHASE power lead
If the machine does not already come supplied with plugs for connection to the power supply (400 V), connect the power
leads to the relative plugs.
Protect the power cables with a differential overload cutout switch.
Should the power supply wire be cut, reset connection referring to the wiring diagram (Cap. 11).
If the direction of blade rotation is not the same as the one shown by the arrow on the machine, invert two of the three
phases of the power supply.
SIKA PLUS MANUAL
2
42
1
07-01