Christopeit Sport EMS 3 Notice De Montage Et D'utilisation page 17

Assembly Instructions
Before beginning assembly, be sure to observe our recommendations
and safety instruction. Remove all the part of your cycle from the carton
and place them on the floor carefully. Some parts are pre-assembled.
Assembly time: 30 - 40 min.
Step 1:
Attach the stabilizer (14+41).
1. Attach the front stabilizer (14) assembled with 2 front cross bar caps
(13) to main frame (32), using 2 bolts M8x55 (17), 2 washers (16), 2
spring washers (76) and cap nuts (15).
The transportation wheel of foot-caps (13) need front direction for use.
2. Attach the rear stabilizer (41) assembled with 2 rear cross bar caps (40)
and 2 height adjustable screws (42) to main frame (32), using 2 bolts
M8x55 (17), 2 washers (16), 2 spring washers (76) and cap nuts (15).
(For uneven floor you can adjust the height with screw (42) and secure
position with nut (43).)
Step 2:
Attach the pedals (67L+67R).
1. Attach the pedal straps to the pedals (67R/67L).
(Note: The end with many adjustable holes must be set outwards.)
2. The pedals (67R/67L) are marked with „R" & „L"
Note: Right and Left are specified as viewed seated on the machine
during training. Connect each pedal (67R/67L) to the matching crank
arm (66L+66R)
(Note: The right pedal „R" should be threaded on clockwise. The left
pedal „L" should be threaded on counter-clockwise.)
Step 3:
Installation of saddle (44) at saddle support (69) by using saddle slide
(75).
1. Push the saddle (44) with saddle bracket into the movable saddle slide
(75) and tight it up in desired gradient position.
2. Place the movable seat post (75) into the holder of saddle post (69),
set it at the desired horizontally position and tighten it by washer (71)
and movable seat knob (70).
3. Insert the saddle support (69) into the provided holder of the main frame
(32) and secure at the desired position by screwing in the rapid action
lock (60).
(Note: To screw in the rapid-action lock (60), the threaded hole in the
main frame (32) and one of the holes in the saddle support (69) must
be aligned. Furthermore, ensure that the saddle support (69) is not
pulled out of the main frame beyond the marked maximum Position.
The setting of the saddle post can be adjusted as desired later. For this,
the rapid action catch (60) must be loosened by only a few revolutions,
the cap of the lock must be pulled away and the saddle adjusted. Then
secure the new setting by tightening the rapid action catch.
17