Mounting To A Wall; Mounting The Control Unit - Dedicated Micros Dennard 2025 Manuel D'installation

7. Mounting to a Type 2000 Pan and Tilt Unit
Figures 2 and 3 show typical positions for I.R. illuminators when mounted to a remotely controlled
Dennard 2000 pan and tilt head.
Mount the Dennard 2025 illuminator using the M10 fixings supplied with the unit.
Due to the weight of the 2025 it is not recommended that it is used with the optional side mounting
plate on the pan and tilt unit.

8. Mounting to a wall

The illuminator can be mounted directly to a wall to allow up and down adjustment only.
Alternatively it can be mounted using the wall mounting bracket provided which also allows left to
right adjustment. See figure 4.
WARNING: Ensure the wall fixings used are suitable for the type of wall and can support the full
weight of the unit.

9. Mounting the Control Unit

Remove the sealing plugs as shown in figure 5 and then use the rawlplugs, screws and rubber
washers provided to mount the control unit to the wall. Use silicon sealant between the wall and
unit to ensure a water tight seal is maintained.
2025 Installation Manual Page. 6