Adjusting The Illuminator Angle - Dedicated Micros Dennard 2025 Manuel D'installation

13. Adjusting the Illuminator Angle

Once you have completed the connections and have powered on the illuminator you will need to
set the angle to get the best possible performance.
• View the area you wish to illuminate through a camera and monitor.
• If you are using the wall bracket then loosen the bolt on the bracket and move the illuminator so
it is pointing towards the area you wish to see. Tighten the bolt.
• Loosen the bolts on the side of the illuminator and tilt the lamp downwards until the near part of
the view is clearly illuminated. (viewed via the monitor).
• Slowly tilt the lamp upwards until the far part of the field of view is also illuminated. Tighten the
bolts to set this position.
2025 Installation Manual
IR Illumination
Nearest Object
Figure 10 – Adjusting the Illuminator Angle
Furthest Object
Page. 14