Configuration; Power Settings - Dedicated Micros Dennard 2025 Manuel D'installation

CONNECTION TO 2025 PSU
6mm STRIP A N D
P R E P F O R
T E R M I N A L
B L O C K
G R E E N / Y E L L O W
E A RT H

11. Configuration

Power Settings

It is possible to configure the supply at 4 different power levels. The factory setting is high power.
If using the lamp at temperatures above 40 degrees C or using continuously it is recommended that
you use Medium power or lower to maximise the life of the LEDs.
Switch 1 and 10 in the switch bank control the power level settings. The factory default setting is
high power.
2025 Installation Manual
BROWN -
L I V E
BLUE - NEUTRAL
20mm MAX OUTER
I N S U L ATION REMOVED
24mm MIN
Figure 8 Mains Cable Preparation
Switch 1 Switch 10
ON ON
ON OFF
OFF ON
OFF OFF
CONNECTION TO CUSTOMER WIRING
4-6mm OUTER
I N S U L ATION DIAMETER
Power mode
Ultra low
Low
Medium
High
BROWN - LIVE
G R E E N / Y E L L O W
E A RT H
BLUE - NEUTRAL
Page. 11