Recording Operation - Sony BETACAM SX DNW-A28P Instructions D'opération

4-1 Recording
This section describes recording of external input 4-1 Recording
signals.
Note
When two DNW-A28/A28P units are connected, set
both LOCAL/REMOTE switches to LOCAL.
4-1-1 Preparations for Recording
Perform the following procedure.
1
Connect the source signals.
2
Select video and audio signals which you want to
record.
Video: SDI or composite signal (see "0 Source
video signal display" on page 2-17)
Audio: SDI or analog audio signals for each
channel (see pages 2-20 and 2-21).
3
Make settings for reference video signals (see page
2-7).
4
Make settings for timecode (see page 2-12).
To adjust audio input level
Set the REC/PB audio level PRE/VAR
(subadjustment) switches to VAR. Turn the REC/PB
audio level subadjustment knobs, monitoring the input
levels indicated by audio level meter.
Instead of using the REC/PB audio level
subadjustment knobs, you can adjust the input level
with the REC/PB audio level main adjustment knobs.
To do so, set MAIN VR on the submenu to REC (see
page 2-20).

4-1-2 Recording Operation

Confirm that the cassette type display on the FL
display panel is "SX" and that the REC INHI indicator
on the control panel is not lit.
Then, follow the procedure below.
TC
00 : 00 : 00 : 00
AU-1 AUTO
1
Press the SEQ/REC and DATA/PLAY buttons at
the same time.
2
Press the STOP button to stop recording.
If recording continues to the end of the tape, the
tape automatically rewinds to the beginning and
stops.
Chapter 4 Recording and Playback
525 SX-- BATT
VITCON SDI
1
2
4-1