Christopeit Sport RUNNER PRO MAGNETIC Mode D'emploi page 16

Step 7:
Checks
1. Check the correct installation and function of all screwed and plug
connections.
2. When everything is in order, familiarise yourself with the machine at a
low resistance setting.
Note:
Please keep the tool set and the instructions in a safe place as these may
be required for repairs or spare parts orders becoming necessary later.
Possible faults and their remedies
Most faults which can occur can be rectified by the following, simple
steps.
1. The computer no longer operates correctly
a) Check that all plugged connections are made correctly.
b) Check whether the batteries still have sufficient capacity/power.
2. The belt (2) no longer runs evenly
To achieve even running and to reduce the friction between the belt (2)
and the board (34), you should apply a silicone-based lubricant
occasionally on the slip surface beneath the belt (2). Ensure that the
lubricant is not based on an oil or petroleum compound.
3. The belt (2) no longer runs centrally or slides
a) If the belt (2) has run to the left of the direction of running, turn the left
screw (58) clockwise and the right screw (58) anticlockwise by a
quarter of a revolution each. Run briefly on the belt.
If the belt still does not run centrally, repeat the above procedure.
b) If the belt (2) has run to the right of the direction of running, turn the
left screw (58) anticlockwise and the right screw (58) clockwise by a
quarter of a revolution each. Run briefly on the belt. If the belt still does
not run centrally, repeat the above procedure.
c) If the belt (2) slips, turn both screws (58) clockwise by a quarter of
a revolution. Run briefly on the belt. If the belt (2) still slips, repeat the
above procedure.
Instruction for a mechanical treadmill, slowed down magnetically.
Settle the treadmill on an even ground and lock it with the handgrip
screw (Abb. 10) for the training start.
And also lock it with the round handgrip screw (Abb. 30) for the fold up
condition as mentioned in the instructions (step 6)
The stability of the piece of apparatus is not to be endangered by putting
something under the treadmill
like a piece of wood or something similar. Guarantee before starting the
training that treadmill is not loaded
higher than with the maximum permissible weight of body and that there
is enough space for security of 2 000 mm x 1 000 mm.
Run in the middle of the running surface, hold yourself tight and don't
step on the slip board (31) or on the foot mats (Abb. 34). Only run in
increasing with look at the Computer on the treadmill.
during the running. In emergency step of the treadmill lateral and hold on
to the handle (Abb. 6+7) When nobody is on the
treadmill it will stop automatically .
16
58 58 58 58 58