Maytag YMIR8890AS Instructions D'utilisation page 19

PROBLEM
Cooktop display shows
messages
Is the display flashing "F" or
"C" and numbers? If "F" or "C"
and a number are alternately
flashing on the display, refer to
the following for possible
solutions:
Cooktop has turned off and is
beeping every 10 seconds.
F42, F43
C81, C82, C83
F12, F21, F25, F36, F37, F40,
F47, F56, F58, 560, F61, F62,
F63, F64
Mineral deposits are left on the
oven bottom after the Clean
cycle
POSSIBLE CAUSES
Improper pan being used
("replace pan" animation showing
in the display when you place a
saucepan on an induction
surface cooking area)
Long cooking time (performance
boost function display flashing
and switching off)
Error code (display flashing "Er"
and numbers)
An object, liquids or soils are
putting pressure on the control
panel.
The power voltage is too low or
too high.
The surface cooking area has
overheated.
Tap water was used in the Clean
cycle.
Range is not level.
SOLUTIONS
See "Pan Detection" in the "Cooktop Use" section. Check that
the saucepan is ferromagnetic. Check that the diameter of the
saucepan is large enough. Center the saucepan on the surface
cooking area. Allow the saucepan to cool down in the event
that it has become hot when used. Switch the surface cooking
area off, then on again. If the display still does not light up, turn
power off at the circuit breaker. Wait 20 seconds and turn
power back on.
The Performance boost function operates the surface cooking
area with the most power. During long cooking times, it is
possible that the function will switch the surface cooking area
off to keep the cooktop from overheating. You can continue to
use the cooktop if the display is not flashing.
If an "Er" and a series of numbers appear in the display panel,
turn power off at the circuit breaker. Turn on again. If problem
continues, call customer service. See the cover for contact
information.
Thoroughly wipe or remove any object on touch keys.
Turn off the cooktop. Wait 5 seconds, then turn it back on. If
this continues, contact a qualified electrician.
The surface cooking area automatic shutoff was activated. Wait
5 minutes for it to cool down, then turn it back on.
Call for service. See the cover for contact information.
Use distilled or filtered water in the Clean cycle.
To remove deposits, use a cloth soaked with vinegar. Then use
a cloth dampened with water to thoroughly remove any vinegar
residue.
Mineral deposits will collect on dry areas of the oven bottom
during the Clean cycle. Level the range. See the Installation
Instructions.
To remove deposits, use a cloth soaked with vinegar. Then use
a cloth dampened with water to thoroughly remove any vinegar
residue.
19