Remedy Of Faults - Oase EAC Aquarium Controller Notice D'emploi

- EN -

REMEDY OF FAULTS

Many faults can be avoided if the current version of the OASE app is used and the smartphone/tablet operating
systems is always kept up to date.
Malfunction
The WIFI connection is not es-
tablished, although the network
name is displayed in the WIFI
settings
The EAC Aquarium Controller is
not reacting to commands.
The connected EAC device is not
reacting to commands
Red LED flashing
18
Cause
The smartphone/tablet cannot up-
date the entered connection data for
the network.
The WIFI standard set in the WIFI
router is not compatible with the EAC
Aquarium Controller.
WIFI is deactivated on the
smartphone/tablet.
Sources of interference between the
smartphone/tablet and EAC Aquar-
ium Controller
Too large a distance between the
smartphone/tablet and the EAC
Aquarium Controller
The power supply of the EAC Aquar-
ium Controller is interrupted.
The receiver in the EAC Aquarium
Controller is defective.
The OASE app is an older version
The operating system of the
smartphone/tablet is outdated.
The data cable is interrupted.
The EAC device has no power supply
The power adapter is connected in-
correctly
Internal error
Remedy
iOS:
· Select the network and touch i.
· Touch the "Ignore this network" button to re-
move the network
· Then establish a connection with the network
again.
Android:
· Select the network and touch "Remove" to re-
move the network.
· Then establish a connection with the network
again.
EAC Aquarium Controller supports the WIFI stand-
ards 802.11n+g+b (only in the frequency range 2.4
Ghz).
· If necessary, select the correct WIFI standard on
the router (see WIFI router operating manual)
Activate the WIFI on the smartphone/tablet and es-
tablish a connection to the EAC Aquarium Controller
· Reduce the distance between the
smartphone/tablet and the EAC Aquarium Con-
troller.
· Select a different location for operating by
smartphone/tablet.
· Ensure that there are no obstructions between
the EAC Aquarium Controller and
smartphone/tablet.
· Reduce the distance, do not exceed the max.
range of 80 m.
· Use an off-the-shelf repeater to increase the
range.
Establish power supply
Contact the OASE service.
Install the current OASE app
Update the operating system.
Check the EAC connections
Establish power supply
Observe the power adapter instructions
· Disconnect from the power supply, wait for 10
seconds and then reconnect.
· Reset the EAC Aquarium Controller to the factory
default settings.
EAC Aquarium Controller