Led Display; Network Connection - Oase EAC Aquarium Controller Notice D'emploi

- EN -

LED DISPLAY

The operating status of the EAC Aquarium Controller can be determined from the status LEDs on the LED display.
The device requires a few seconds to become ready after you switch it on.
5 A
LED colour LED status
– Off
Green Lit
Flashing fast
Flashing slowly (2 seconds on,
1 second off)
Yellow Lit
Flashing slowly (2 seconds on,
1 second off)
Green + yellow Lit
Green lit / yellow flashing
Red Flashing

NETWORK CONNECTION

The EAC Aquarium Controller and the smartphone/tablet must be connected via WIFI to operate.
Possible connection types
WIFI connection
Connect the EAC Aquarium Con-
troller and smartphone/tablet to
the WIFI router of your home net-
work with WPS.
Directly connecting the EAC Aquar-
ium Controller and
smartphone/tablet
Connect the EAC Aquarium Con-
troller and smartphone/tablet
manually via the WIFI router of the
home network.
14
Description
EAC Aquarium Controller is switched off.
EAC Aquarium Controller is ready for operation and in Access
Point mode.
WPS is activated, EAC Aquarium Controller is waiting for the
WIFI router access data
EAC Aquarium Controller is ready for operation and connected
to the WIFI router.
The EAC Aquarium Controller is starting up
EAC Aquarium Controller is searching for a connection to the
WIFI router.
The EAC Aquarium Controller is in update mode
Firmware Update in progress
Malfunction
Remedy:
· Disconnect from the power supply. Wait for 10 seconds then
reconnect.
· Reset the EAC Aquarium Controller to factory settings
· Carry out a firmware update
Description
· The smartphone/tablet stays connected to the WIFI
router.
· EAC-compatible end devices can be controlled via the
OASE web portal
· The smartphone/tablet can access the internet.
· The EAC Aquarium Controller and smartphone/tablet are
not connected to the home network.
· EAC-compatible end devices cannot be controlled via the
OASE web portal.
· Smartphone/tablet cannot access the internet.
· The smartphone/tablet stays connected to the WIFI
router.
· EAC-compatible end devices can be controlled via the
OASE web portal
· The smartphone/tablet can access the internet.
How to proceed
(→ Connecting to the
WLAN router via WPS)
(→ Establishing a direct
WIFI connection between
the EAC aquarium con-
troller and the
smartphone/tablet )
(→ Connecting to the
WIFI router manually)
EAC Aquarium Controller