Remedy Of Faults - Oase InScenio FM-Master 1 Notice D'emploi

Connect the units to the power supply distributor
This is how to connect your OASE unit to the power supply distributor:
• If necessary, remove the protection hood from the power supply distributor.
• Select a suitable socket from the following table.
• Make sure that your OASE unit may be connected to this socket. For this purpose, consult the instructions of use of
the unit you wish to connect.
The following is to be taken into consideration: Units powered via a transformer may not be connected to a socket
with dimmer function.
• Connect the unit.
• Always use the pull relief (E, 9) provided on the unit for the connection cables.
• Refit the protection hood to the unit.
Operation
How to operate the manual transmitter:
LED Control lamp
O switch off
I switch on:
– + dim

Remedy of faults

Malfunction
Unit does not respond to commands from the
manual transmitter
Supplemental instructions for operation
• After a power outage the power outlets are switched off.
• Do not connect any InScenio controllers or portable multiple sockets to the unit.
• The device is only de-energised when the plug of the mains supply cable is unplugged.
InScenio FM-Master 1
1 Socket 1, with switch
function
2 Socket 2, with switch
function
3 Socket 3, permanent
4 Socket 4, permanent
InScenio FM-Master 1 InScenio FM-Master 2 InScenio FM-Master 3
a Socket 1, switch
b Socket 2, switch
c no function
d no function
Receiver in the unit does not receive from the
manual transmitter
Interference over radio distance
Receiver in the unit defective
Dead battery in the manual transmitter
(LED of the manual transmitter does is not lit)
Fine fuse has tripped because an unsuitable unit
was connected to the socket with dimmer function
(only InScenio FM-Master 1, 2, 3)
InScenio FM-Master 2
1 Socket 1, with switch
function
2 Socket 2, with switch
function
3 Socket 3, permanent
4 Socket 4, with switch
function
a Socket 1, switch
b Socket 2, switch
c Socket 4, switch
d no function
Cause
InScenio FM-Master 3
1 Socket 1, with switch func-
tion
2 Socket 2, with switch func-
tion
3 Socket 3, permanent
4 Socket 4, with switch and
dimmer function
a Socket 1, switch
b Socket 2, switch
c Socket 4, switch
d Socket 4, dim
Remedy
Teach-in manual transmitter
Choose a different place, ensure unob-
structed view
Contact the OASE service
Change battery
Replace fuse
Only connect suitable devices to a socket
with dimmer function
- EN -
13