Water Separator-Alert Indicator Blinks While Cruising - Yamaha F150 Manuel De L'utilisateur

1. Manual valve screw
3. Tilt the outboard motor up manually to
the desired position, and then tighten the
manual valve screw by turning it clock-
wise.
EMU44521
Water separator-alert indicator blinks
while cruising
EWM02543
WARNING
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
 Do not perform this procedure on a hot
or running engine. Allow the engine to
cool.
 There will be fuel in the fuel filter. Keep
away from sparks, cigarettes, flames or
other sources of ignition.
 Some fuel will spill during this proce-
dure. Catch the fuel in a rag. Wipe up any
spilled fuel immediately.
 The fuel filter must be reassembled
carefully with the O-ring and filter cup in
place. Improper assembly or replace-
ment could result in a fuel leak, which
could result in a fire or explosion hazard.
If the water separator-alert indicator blinks,
perform the following procedure.
1. Stop the engine.
2. Remove the top cowling.
Trouble Recovery
3. Disconnect the water detection switch
coupler. NOTICE: Be careful not to get
any water on the water detection
switch coupler, otherwise a malfunc-
tion could occur.
1. Water detection switch coupler
4. Remove the filter cup from the filter
housing, and then remove the O-ring
from the filter cup. NOTICE: Be careful
not to twist the water detection switch
lead when unscrewing the filter cup.
[ECM01961]
4
1. Filter housing
2. O-ring
3. Filter cup
4. Water detection switch lead
5. Drain the water in the filter cup by soak-
ing it up with a rag.
6. Put the O-ring on the filter cup in its orig-
inal position, and then install the filter cup
onto the filter housing. NOTICE: Be
[ECM01951]
1
ZMU08838
1
2
3
ZMU08839
101