TIP:
Trolling is affected by currents and other
operating conditions and may differ from
the actual engine speed.
When warming up a cold engine, the troll-
ing speed cannot be decreased below the
specified engine idle speed.
EMU27822
Stopping engine
Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU41913
Procedure for stopping engine
1.
The engine can be turned off either by
pressing the Start/Stop button or by
turning the main switch to the "
position. After the engine has been
turned off using the Start/Stop button,
turn the main switch to the "
sition.
ZMU06309
ZMU08536
TIP:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to "
2.
Remove the key if the boat will be left un-
" (off)
attended.
" (off) po-
Operation
ON
OFF
" (off).
ZMU07171
ZMU07148
ZMU07150
67