Removing Propeller; Installing Propeller - Yamaha F150 Manuel De L'utilisateur

Maintenance
1. Propeller shaft
EMU41992

Removing propeller

1. Straighten the cotter pin and pull it out
using a pair of pliers.
2. Remove the propeller nut, washer, and
spacer. WARNING! Do not use your
hand to hold the propeller when loos-
ening the propeller nut.
1. Cotter pin
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Thrust washer
3. Remove the propeller and thrust washer.
EMU41962

Installing propeller

EWM00771
WARNING
On counter rotation models, be sure to
use a propeller intended for counterclock-
wise rotation. These propellers are identi-
90
1
ZMU07855
[EWM01891]
6
5
4 3
2
ZMU07900
fied with the letter "L" after the size
indication on the propeller. Otherwise the
boat could move in the opposite direction
from that expected.
ECM00502
NOTICE
Make sure to use a new cotter pin and
bend the ends over securely. Otherwise,
the propeller could come off during oper-
ation and be lost.
1. Apply Yamalube Marine Grease to the
propeller shaft.
2. Install the thrust washer and propeller on
the propeller shaft. NOTICE: Make sure
to install the thrust washer before in-
stalling the propeller. Otherwise, the
lower case and propeller boss could
be damaged.
3. Install the spacer, washer, and propeller
nut. Tighten the propeller nut to the
specified torque.
1
1. Cotter pin
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Thrust washer
Propeller nut tightening torque:
54 N·m (5.51 kgf·m, 39.8 lb·ft)
[ECM01882]
6
5
4 3
ZMU07899
2
1