First Use; Daily Use - IKEA KYLIG Mode D'emploi

ENGLISH
Control panel
A
Fast cool function indicator
B
Indication of temperature settings
First use
Connect the appliance to the main power
supply.
The ideal temperatures for preserving food
have already been set at the factory.(MED)
Daily use
Guide to selecting functions temperature
selection
Press the push button on the control panel
to adjust the temperature. Temperature
selection push button is used to set desired
temperature level, from warmest through
lower to coldest . Pressing push button
setpoint will change cyclically. Temperature
set-point is done for both compartments at
one time - fridge and freezer.
At first plug-in of appliance factory set-point
is chosen - medium position.
Following table shows set-points level:
Legend:
Led OFF
A B
High temperature
Mid-high temperature
Middle temperature
Mid-low temperature
Low temperature
Led ON
C
3"
C
Temperature selection /
Fast cool push button
D
Internal light switch
Note: After switching the appliance on,
it will be necessary to wait for 4 to 6
hours before a temperature suitable for a
standard appliance load is reached.
Fast Cooling
The use of this function is recommended to
increase the cooling speed when placing a
very high quantity of food in the refrigerator
compartiment by pressing and holding
the push button on the control panel for 3
seconds.
Fast cool
ON
The Fast Cool light (yellow LED) will turn on.
The function is automatically deactivated
after 6 hours.
The Fast Cool function can be manually
deactivated by pressing and holding the
same push button on the control panel for 3
sec., the yellow LED is off.
Note: fast cool function should be also
switched ON before placing fresh food to be
frozen in the freezer compartment, in order
to maximize the freezing capacity.
D
Fast cool
OFF
8