IKEA KYLIG Mode D'emploi page 11

ENGLISH
Note:
- Bear in mind that a full appliance will
stay cold longer than a partially filled
one.
- If ice crystals are still visible on the food,
it may be frozen again, although flavour
and aroma may be affected.
- If food is found to be in a poor condition,
it is best to throw it away.
Replacing the LED
Always disconnect the refrigerator from the
power supply before replacing any light
bulb.
If the inside light is not working, it is
necessary to:
1. Remove the light cover: put the fingers
into the side ventilation holes (1), stretch
the cover gently and move it upwards.
2. Check the bulb. If necessary unscrew the
broken bulb and replace it with a LED
bulb of the same type available only at
After Sales Service.
3. Put on the light cover.
Do not leave the bulb uncovered.
Abnormal appliance operation
When the product is plugged in to
the mains, during first 10 minutes of its
performance, possible temperature sensor
failure will be displayed according to
following table:
Refrigerator Evaporator
sensor failure
Refrigerator sensor failure
Refrigerator & Evaporator
sensor failure
Legend:
Led off
The appliance will work preserving the food
stored, but it is necessary to contact after-
sales service and provide alarm code.
Led flashing
1 1