Christopeit Sport R 10 Mode D'emploi page 16

Step 7:
Attach the computer (1) at computer holder (6) and the pre-assembled
seat unit at rear frame (72).
1. Place the seat support tube (81) near to the holder at rear frame (72) and
put the ends of pulse connection cable 2 (83) and pulse connection cable
1 (78) together.
2. Put the pre-assembled seat unit into the holder at rear frame (72) and
adjust that the holes are align.
3. Put on each screw M8x15 (76) one spring washer (12) and one washer
(11) and tighten the seat support tube (81) at rear frame (72) fi rmly.
4. Take the computer (1) that has been supplied out of the packaging and
insert batteries (Type "AAA"-1.5 V pencells) by watching for the right po-
larity on the back of the computer (1). (Batteries for the computer are not
included in this item. Please buy them at your located market.)
Place the computer (1) near the computer holder (6) and put connection
cable (2) into the associated socket of computer (1).
5. Put the computer (1) onto the computer holder (6) without squeezing the
connection cable (2) and screw it fi rmly by using screw M5x10 (4).
6. Finally put the plug of hand pulse cable (3) into associated socket of rear
side of computer (1).
Step 8:
Checks
1. Check the correct installation and function of all screwed and plug con-
nections. Installation is thereby complete.
2. When everything is in order, familiarise yourself with the machine at a
low resistance setting and make your individual adjustments.
Note:
Please keep the tool set and the instructions in a safe place as these may
be required for repairs or spare parts orders becoming necessary later.
16