Christopeit Sport R 10 Mode D'emploi page 15

Step 4
Attach the rear frame (72) at front frame (20).
1. Place the rear frame (72) near to the holder at front frame (20) and put the
ends of pulse cable (3) and pulse connection cable 1 (78) together.
2. Insert the rear frame into the holder of front frame (20) by turning out
and pulling out the quick release knob (15) and secure desired position by
locking up with quick release knob (15).
(Choose your desired seat position for smooth exercising!)
Step 5:
Attach the seat (77) and back cushion support (75) at seat support
(81).
1. Place the seat (77) with back side and back cushion support (75) onto
the seat support tube (81) so that the holes are align.
2. Put on each screw M8x25 (84) one spring washer (12) and one washer
(42) and tighten the seat (77) with back cushion support (75) at seat sup-
port tube (81) fi rmly.
Step 6:
Attach the hand pulse bar (67) and back cushion (73) at back cushion
support (75).
1. Put on each screw M6x15 (76) one spring washer (69) and one washer
(47).
2. Place the hand pulse bar (67) at appropriate holder at back cushion
support (75) and tighten it fi rmly by using the screws (70).
3. Put the ends of pulse connecting cable 2 (83) (projecting from seat sup-
port tube (81) and pulse connecting cable 3 (64) (projecting from hand
pulse bar) together.
4. Place the seat (77) with back side against the back cushion support (75)
so that the holes align.
5. Screw the back cushion (73) at back cushion support (75) tightly by
using screws M8x45 (68), spring washers (12) and washers (42).
15