Unitron uTV 3 Guide D'utilisation page 9

Signal priorities:
Normally it is enough to connect one audio
cable. If more than one cable is connected and
a signal is present, uTV 3 will select the best
possible input in the following order: optical,
coaxial, analog.
1 2
3
Note: even though the optical and coaxial
cables are only one wire, the signal is stereo.
uTV 3 shows the selected input by an orange
audio indicator light:
Input selected
Input selected and
audio available
8
Slow blink orange
Solid orange
Option 1: connecting via optical cable
If an optical output is available:
Unpack the cable labeled "Optical"
•
Remove the protection caps from the plugs
•
Connect one end of the optical cable into the
•
"Optical" input of uTV 3, and the other end
into the optical output of your TV
9