Unitron uTV 3 Guide D'utilisation page 12

Changing the charging slot for your streamer
The uTV 3 comes with two charging slots. You
may need to change the slot using a Phillips
head screwdriver.
1. Unplug the USB power cable.
2. Unscrew the screw on the bottom of the
uTV 3. Lift the charging slot to remove.
3. Insert the other slot into the opening.
Replace the screw at the bottom and gently
tighten it.
14
When using your streamer for the first time,
charge it for at least three hours even if the
battery indicator turns green earlier. After the
initial charge, you may leave the streamer in
the charging slot for and unlimited time.
uStream uDirect 3
Charging is complete when the streamer's
indicator light turns solid green.
The uTV 3 can either be on or off during
charging. Its status indicator light does not
indicate the charging process.
The typical time to fully charge the streamer
is 90 minutes.
We recommend that the streamer is switched
off while charging.
For safety reasons, recharge the battery
only with chargers supplied by Unitron. If
other chargers are used they must be USB
certified (5.0 VDC / 500 mA).
15