Beginning Work With The Machine - Taski AERO 3500uicro Manuel D'instructions

Beginning work with the machine

Caution:
Always wear slip-resistant shoes and appropriate
working clothes when working with this machine!
Caution:
To ensure safe operation, always keep both hands
on the steering wheel/driving handle while operat-
ing the machine.
Caution:
When driving the machine for the first time, test it
out in an empty space to get familiar with the ma-
chine.
Warning:
Before beginning work (in the work position), check
whether your field of vision is sufficient to ensure
safe working. EN 3411 must be adhered to.
An insufficient field of vision can make work difficult and
therefore impair safety for the operator, machine, and
third parties.
Warning:
While working, pay attention to the maximum clear-
ance height for doors and underpasses shown on
the warning sign on the machine.
Danger:
If there is a danger of falling objects while the ma-
chine is in use, the necessary safety precautions
must be taken or adhered to in accordance with na-
tional regulations.
Notice:
When working in public buildings, the warning light
must be switched on.
• Sit down on the driver seat.
• Check whether the emergency stop button is released.
• Switch on the machine (key switch).
The indicator elements will light up briefly.
Starting the machine using the program button
• By pressing the program button for
the next operation start or work step,
all machine functions are started on
the basis of the functional values last
used.
Notice:
The set values can be adjusted at any time during
operation.
The values set when the machine is switched off are
stored and will be automatically activated when the ma-
chine is restarted.
Notice:
Pressing the program button when the cleaning
process is finished will start an optimized program
for the end of operation. See instructions on page
11 in the "Automatic process" chapter.
Settings and activated functions are saved.
10
Cleaning start
• If the machine is switched on and the
operator is sitting in the driver's seat,
the machine will start moving as soon
as the gas pedal is depressed. The
brush unit and side broom are acti-
vated.
Notice:
The speed is controlled by the position of the gas
pedal. When the gas pedal is released, the machine
will automatically decelerate until it stops and the
parking brake is activated.
The side broom and the brush unit are stopped.
Caution:
When working in restricted or narrow areas, it is
recommended to press the slow approach ON/OFF
button. (Display lights up)
This reduces the maximum working speed, thus also re-
ducing the risk of accidents.
• Pressing this button once more will
override this restriction and the dis-
play will disappear.
Brush unit setting
The brush unit can be individually set for two different types of floor-
ing.
• In order to configure the setting, acti-
vate the carpet/hard floor setting but-
ton.
The configured selection will be
shown on the operating panel.
Working modes
This machine has two different working modes. An auto and manual
mode.
Auto mode Manual mode