Kong ORTLES Instructions D'utilisation Et D'entretien page 9

ASSEMBLY OF THE ORTLES WINCH ON THE FISHING POLE
First of all assemble the two pieces of the pole by inserting them one in the other. Then insert the
Ortles winch plate in the two fixed tongues in the lower sector where the hole is placed (picture
10), insert the screw with the hand lever in the threaded bush (slightly move the plate to make
the going in easier), screw two or three turns. Do the same in the two upper tongues, then screw
tight without forcing too much (picture 11).
FIG. 10 FIG. 11
After assembling the Ortles winch, position the pole so that its upper end is as close to the vertical
of the dropping point as possible in order to avoid dangerous oscillations during the dropping or
the rescue. Now the winch is ready for being fastened to the ground through appropriate anchor
devices (screw anchors, nails etc.).
A special larger-size plate can be combined with the small plate in case of soft ground, such as
snow, meadow etc. (picture 12).
FIG. 12
KONG s.p.a. Zona Industriale -
6
via XXV Aprile, 4 - 23804 MONTE MARENZO (LC) - ITALY
TEL. + 39 0341 630506 • FAX. + 39 0341 641550 • EMAIL: kong@kong.it • WEB SITE: http://www.kong.it