Kong ORTLES Instructions D'utilisation Et D'entretien page 7

ASSEMBLY OF THE ORTLES WINCH ON THE REST PLATES
A) Position the right plate upside-down with the threaded bushes upwards (picture 2).
B) Position the plate with the winch downwards and insert it in the two threaded bushes
(picture 3).
C) Now lay the left plate matching the holes with the bushes (picture 4).
D) Insert the crank screws screwing them tight but without forcing too much (picture 5).
FIG. 2
FIG. 4
FIG. 6
The gripping levers can be released from the screws by axially pulling them: this allows their
turning in the most comfortable position (picture 6).
If possible (unlike the fishing pole), place the winch with the rest plates at 3/5 meters from the
wall edge so as to have the largest possible room for operating it (picture 7).
KONG s.p.a. Zona Industriale -
TEL. + 39 0341 630506 • FAX. + 39 0341 641550 • EMAIL: kong@kong.it • WEB SITE: http://www.kong.it
via XXV Aprile, 4 - 23804 MONTE MARENZO (LC) - ITALY
FIG. 3
FIG. 5
FIG. 7
Ideal distance
winch/wall
3 ÷ 5 m
4